cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Field Notice 70545
897
Views
0
Helpful
0
Replies
Luke Poskitt
Beginner

Cisco UCS sup-eth pinning

Hi All,

 

Probably a silly question, but is there any way to modify the uplink pinning of sup-eth interface, or is there a document that provides further information on how this interface is pinned, and what the potential impact of pinning it to a disjoint layer 2 uplink may potentially have?

 

Example:

 

ucs-A(nxos)# show pinning border-interfaces

--------------------+---------+----------------------------------------
Border Interface Status SIFs
--------------------+---------+----------------------------------------
Po1    Active sup-eth2 Veth3504 Veth3536 Veth3544

 

Specifically, in my case; I would like to create a new uplink port-channel and confirm that the port-channel is operational.  Unfortunately, immediately upon configuring the port-channel, the dynamic pinning of the sup-eth2 interface changes from its current uplink to the new port-channel.  I'm concerned over what impact this may have as the new port-channel is to a disjoint layer 2 network.

 

Cheers,

 

-Luke

0 REPLIES 0
Create
Recognize Your Peers
Content for Community-Ad