12-20-2017 05:53 AM - edited 03-01-2019 01:23 PM
I have a S3260 chassis with one server and one SIOC. Creating a service profile for the S3260M4 server with only network NIC's is no problem but as soon as I configure FC HBA's in it comes out with configuration-failure due to insufficient resources.
Configuration on standard B Series blades goes OK. What am I missing?
12-20-2017 05:58 AM
So I see it is referencing a connection placement policy. Did you create a placement policy and not add any vHBA to that policy? I could see where it would error out on that step if this were the case.
Otherwise, remove the connection placement policy and attempt to add vHBA again.
12-20-2017 06:03 AM
12-20-2017 06:12 AM
No you don't need a placement policy. Are all your adapters and DCE interfaces discovered correctly?
Have you tried to decom and re-ack the blade to make sure everything is showing up properly?
10-04-2018 11:08 AM
i am having this same issue? did you end up resolving this?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide