DHCP Server VM on UCS-E 160S Me/K9 Not serving up IP Addresses
we are trying to deploy a windows server vm on our UCS-E 160S Server to act as the local DHCP Server. However, it seems the DHCP requests are not making it to the server. Has anyone done this successfully? The VLANs are defined on the 4331 router as sub-interfaces and we have an ip helper-address defined on the sub-interfaces. We have the static route that points to ucse1/0/1 for the DHCP Server VM.
VLAN IP's are defined on sub-interfaces of G0/0/1
interface ucse1/0/1 ip unnumbered GigabitEthernet0/0/1 ip nat inside ip nbar protocol-discovery no negotiation auto switchport mode trunk no cdp enable no mop enabled no mop sysid service-policy input Mark-Inbound
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...