I seem to keep getting an error about SRIOV bios policy settings, or 'cannot derive mac address from virtual port' when i follow guides for setting up VM-FEX for ucsm and vmware 5.1.
Are there any fully-featured guides that go through more than just each 'side' of the configuration (ucsm or vmware)?
I want to know, from the beginning, what ucsm method i should use if i want ucsm to manage the vlan/dvs in vmware so that i dont' have to keep creating vlans in ucsm, adding them to service profiles, and then in vmware creating the vm networks for those vlans and finally assigning a vm to use that new vlan.
and then, assuming it's vm-fex, how to actually get that configured in ucsm and how to appropriately configure service profiles for that use.
when you integrate vmware and ucsm, should existing VMs show up in ucsm, or only after they are set to use the dvs? All i see is the dvs and thos port profiles.
All the documentation i've found simply shows one 'part' of this whole setup, and i haven't been able to find a solution guide to describe how to configure the service profiles in ucsm to take advantage of vm-fex that work for me.....I keep getting the above mentioned errors when i try to associate the service profile with my ucs210 equipment.
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...