cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1788
Views
0
Helpful
0
Replies

FI's uplink ports Error Disabled on ENM loop

mloeser
Cisco Employee
Cisco Employee

Hi,

I have two UCS6120XP FIs connected to a Cat2948G-GE-TX switch via port 1/3 on each FI. One port on the Cat2948G-GE-TX acts as the uplink port and is connected to the LAN. All ports of the Cat2948G-GE-TX are in VLAN 1 to allow all connected devices to reach the Gateway via the LAN uplink port.

Now after a while both ports 1/3 on the FIs get error disabled on ENM loop.

'show cdp neighbor' on the Cat2k shows FIs hanging off of 2/45 & 2/46. The management ports of both FIs are connected to ports 2/1 and 2/2 of the

Cat2948G-GE-TX as well, as are some other devices.

I'd like to keep both FI uplink ports enabled for failover scenarios - how can I achieve that w/o the ports getting error-disabled?

Thanks,

Matthias

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: