04-30-2020 02:02 AM
Hi,
Is it supported to connect a HX Node with VIC 1457 and 6332-16?
It has sixteen 10G Ports, so it should be officially supported, right?
Solved! Go to Solution.
04-30-2020 04:00 AM - edited 04-30-2020 04:24 AM
Yes, you can use the 10Gb ports on 6332-16UP in combination with vic 1457 for a Hyperflex configuration.
Don't forget to use MLOM 1457 port 1 to FI-A and port 3 to FI-B
Kirk...
04-30-2020 02:39 AM
As long as you are using supported SFPs or cables there should not be any problem.
You can refer below link to check supported cables or SFPs with 6332-16 FIs.
04-30-2020 03:13 AM
04-30-2020 03:35 AM
If you are looking for confirmation from Cisco side then please refer section "Supported switches with VIC 1455/1457" in below link and your FIs are supported with this VIC.
Kindly note that this card is supported only on M5 generation C series servers and also make sure that you run recommended firmware and UCSM version. You can find this information also on the above link.
Please don't forget to mark this as solution if it solves/answer your question.
04-30-2020 04:00 AM - edited 04-30-2020 04:24 AM
Yes, you can use the 10Gb ports on 6332-16UP in combination with vic 1457 for a Hyperflex configuration.
Don't forget to use MLOM 1457 port 1 to FI-A and port 3 to FI-B
Kirk...
04-30-2020 04:04 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide