Is Service Profile Association Automation is possible?

[Muhammad321]

Hi Everyone,

Hope you are all doing good.

My Question is that if we have associate a service profile with a blade-1 on a chassis and we have some other servers as well on the same chassis let say Blade-2 and Blade-3 which has the same specs as Blade-1 but they are not in use by any service profile in UCS Manager. In UCS Manager can we make any kind of automation, if Blade-1 would fail so the service profile that was associated on that blade will automatically disassociate and re-associate itself with the next available server in the UCS Manager?

Is it possible to do this or not?

Thank you so much in advance.

Best Regards

Muhammad Hasan

[Manish Gogna]

Hi Muhammad,

It appears that automatic failover of SP to another blade is still not supported. You can check the following post for similar query , it is a bit old but still applies

https://supportforums.cisco.com/discussion/11094066/service-profile-failover

Manish

[Keny Perez]

correct!  it is still valid, we do not support that kind of failover... you also may end up not knowing where your server is...

-Kenny