The plan is migrate the uplinks from a fews 6500 to a couple Nexus 7000 using pingroups with no trafic disruption. So i have made a desing but i not sure if this is the best way to accomplish the objective without problems.
This is the desing:
There will be two (new) PINGROUPS (All the server use two VNICs) that will be facing to the nexus using the PO 108 and PO 109, is this a good configuration? the nexus are using VPC towards the fabric; the fabric are in EHM.
We made a couple of test moving the vnic into the pingroup and it work fine, but i want to know is this configuration is good.
This works ok; however, best practise in UCS design is using dynamic pinning, and not static pinning (what you are doing). In your case, dynamic or static pinning will have the same result; however, the managment overhead for static pinning is bigger; for every interface, you have to add the pingroup, and if you forget, it will fall back to dynamic pinning.
Many users of technology in today's workforce are considered "remote workers". We have laptops, tablets, smartphones, etc. that allows us to stay connected if we choose ~96.259% of the time (personal "guestimate" percentage). When you get down to ...
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...