I've been battling with a Windows Blade, that refuses to see all 4 storage paths, for a few days so thought I'd see if any of you can help out.
NetApp Clustered Mode, 2 nodes, 8.3
Lots of ESXi 6 Hosts, iSCSI boot, 4 paths
I've installed Windows Server 2012 R2 on a B200-M4 blade with a single path to the NetApp.
Installed UCS drivers for eNIC and Chipset.
Installed Windows Updates
Installed NetApp Host Utils (7.0)
Installed NetApp MPIO (4.1P1)
Put my boot policy back to having 4 paths, 2 targets in VLAN 201, and 2 targets in VLAN 203.
The server boots and runs fine but I only see 1 path through VLAN 201 and 1 path through VLAN 203. I can ping the target addresses, the VLANs are set to native and I'm pretty sure that my config is right as I have 10 ESXi 6 hosts all running nicely on 4 paths!
Cisco UCS Platform Emulator, Release 4.0(4ePE1)
CONFIGURATION IMPORT NOTE: Importing configuration backups (All, System, or Logical) taken from the UCS Platform Emulator (UCSPE) to physical UCS Manager domains is not recommended or supported...
Many users of technology in today's workforce are considered "remote workers". We have laptops, tablets, smartphones, etc. that allows us to stay connected if we choose ~96.259% of the time (personal "guestimate" percentage). When you get down to ...
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•Field guides are meant to be used by customers for cleaning up an existing HyperFlex Edge or HyperFlex DC FI deployments for the purposes of reinstalling.
•The procedures in these guides are DESTRUCTIVE. Make sure all VMs and data...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...