I have a L2 disjoint setup (FIA and B) and vlans 10 and 20 pinned to portchannel 2 and vlans 110 and 120 pinned to pc 3. I have 2 vnic from updating template one on FIA and one on FIB. The vnics have vlan 10 and 20. I read UCS sees the vlans for the vnic on pc2 and sends it that way.
When I remove 10 and 20 and add 110 and 120 traffic does not seem to switch to pc3. I know on updating template adding/removing vlans does take immediate affect but how about a port channel change decision by UCS? should it work or can I use power shell or cli to force a recalculate and send it down pc3?
Have you already removed VLAN 110 and 120 from Po3 using LAN Uplinks manager?
After you make the change, run a 'show run int veth X' on the vNIC in question from nxos to see if its programmed for VLAN 110 and 120. If so, you may just need to flap the vNIC to get it to re-pin to the new uplink. Would need to test in the lab.
One of the great benefits of deploying Cisco's Container Platform on Cisco Hyperflex is the ability to get persistent storage for containers out of the box with minimal configuration. This works well for containers where you require the data to surv...
There has been a few announcements lately regarding Cisco's Container Platform (a.k.a: CCP) and they've all been good. Having integration with AWS allows CCP to deploy Kubernetes clusters on vSphere or EKS from the same control point. But anot...
Sekarang ini untuk mendapatkan situs qq dengan pelayanan terbaik sudah dapat dicari dimana saja. Dengan 8 jenis permainan terbaik seperti pokerqq dan bandarq online sudah di pastikan mulaiqq.com menjadi agen bandarq online terbaik. Juga karena pelayanan y...
Activate your Data with the Power of UCS
Accelerate Deep Learning with the UCS C480 ML M5 Rack Server designed for AI and ML. Learn more about how Cisco AI/ML computing systems and the UCS C480 ML server deliver