cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2350
Views
5
Helpful
4
Replies

Moving RAID to a different server

sperezoplk
Level 1
Level 1

Hi guys!

We have a UCS Serie C210 with a RAID1 and RAID 5 configuration. Recently, we have adquire a new UCS Serie C240 and we want to move the raid to this new server but the raid controllers are different and we dont know if just moving the disk from one server to another will maintain the data on the disk.

Anyone has done this before?.

Grettings.

1 Accepted Solution

Accepted Solutions

David Alpizar
Cisco Employee
Cisco Employee

Hi Samuel ,

In order to swap the RAID controller from server to server, you will need to make sure the device is supported on both servers:

You can check the following link in order to get the supported RAID controllers on the servers C210 & C240:

UCS c210:

http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C210M1/install/RAID.html

This link contains useful info about RAID replacement:

http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C240/install/raid.html#wp1016557

Hope this helps!

- David

View solution in original post

4 Replies 4

padramas
Cisco Employee
Cisco Employee

Hello Samuel,

Can you please provide RAID controller models used in C210 and C240 servers ?

Padma

Hi Padramas1

The model on the c240 is UCSC-RAID-11-C240 the model use on the c210 m2 is LSI MegaRAID 9261-8i.

Hi David thank you for for the response but i have done that method in another server and never worked!

David Alpizar
Cisco Employee
Cisco Employee

Hi Samuel ,

In order to swap the RAID controller from server to server, you will need to make sure the device is supported on both servers:

You can check the following link in order to get the supported RAID controllers on the servers C210 & C240:

UCS c210:

http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C210M1/install/RAID.html

This link contains useful info about RAID replacement:

http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C240/install/raid.html#wp1016557

Hope this helps!

- David

Tausif Gaddi
Level 1
Level 1

The configuration actually lives on the raid controller. It records the serial number of the drives to identify the raid. If you swap the drives then the other server will see it as new drives and attempt to initialize them. If you swap the drives AND the raid controller you should be good to go. Hope it will work. Please make proper backups & refer this link for RAID controller considerations. http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C240/install/raid.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: