I meet a problem.I creat two vhbas in my B200M3 server .one of my vhbas cannot fcping in the SAN switch(the other vhba is normal )，however SAN switch can see it(show npv status in FI is normal,VIF path is up)，just cannot fcping,and we cannot see storage on this side in OS.
OS is redhat 6.1,FI is 6248 in NPV mode,SAN switch is Brocade 48000.other servers in the same chassis is normal too.
is there anyone can give me any advices,thanks very much!!
Upload the Script to Datastore
1. Browse to any Datastore of ESXi Host2. Upload the folder "lsigetvmware_022817" ex. Suppose the datastore name is "Datastore3"
Run the Commands
Enable SSH of ESXi Host
SSH to ESX...
SymptomsCisco Prime is unresponsive. Web GUI will not load. Device doesn't respond to ping.DiagnosisPrime chassis is off.SolutionSince the CIMC uses Flash you can no longer use your bowser. SSH to CIMC address instead. show chassis detailChassis:Powe...
Very first data cloud — Evolution of data lake to hybrid cloud
Today, in this digitized world, data is being generated at a very high rate and from many different sources, and it is growing exponentially in many use ca...
PXE (Preboot eXecution Environment) Server allows unattended or automated OS installation over the Network. The main benefit of pxe is that we don’t need any bootable drive to boot OS(Operating system) and we do not need to to burn any ISO file into DVD o...
New episode on the Cisco UCS X-Series Modular SystemListen: https://smarturl.it/CCRS8E23 Follow us: https://twitter.com/CiscoChampion The Cisco UCS X-Series Modular System simplifies your data center, adapting to the unpredictable needs of...