cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
106
Views
0
Helpful
1
Replies
Highlighted
Beginner

port stats with powertool?

Hi all!

 

Sorry if this is not the correct location for this post.

 

I can ssh to an FI and get the port stats like this:

show interface fc1/30

 

I am specifically looking for 1 min input and output rates as shown in the show interface output:

1 minute input rate 936866512 bits/sec, 117108314 bytes/sec, 62981 frames/sec
1 minute output rate 181196392 bits/sec, 22649549 bytes/sec, 16698 frames/sec

 

Ultimately, I would like to store these values and plot them in Grafana.

I cannot determine how to get this info from Powertool, which would seem to be a much better solution.  Any advice is appreciated!

 

1 REPLY 1
VIP Advisor

Re: port stats with powertool?

we do in same kind of other platform , Logstash and Kibana to blot the same in dash board.

 

i have looked at the document for your requirement, here is example to do so :

 

https://lkhill.com/using-influxdb-grafana-to-display-network-statistics/

BB
*** Rate All Helpful Responses ***
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards