cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
581
Views
0
Helpful
1
Replies

port stats with powertool?

bakins
Level 1
Level 1

Hi all!

 

Sorry if this is not the correct location for this post.

 

I can ssh to an FI and get the port stats like this:

show interface fc1/30

 

I am specifically looking for 1 min input and output rates as shown in the show interface output:

1 minute input rate 936866512 bits/sec, 117108314 bytes/sec, 62981 frames/sec
1 minute output rate 181196392 bits/sec, 22649549 bytes/sec, 16698 frames/sec

 

Ultimately, I would like to store these values and plot them in Grafana.

I cannot determine how to get this info from Powertool, which would seem to be a much better solution.  Any advice is appreciated!

 

1 Reply 1

balaji.bandi
Hall of Fame
Hall of Fame

we do in same kind of other platform , Logstash and Kibana to blot the same in dash board.

 

i have looked at the document for your requirement, here is example to do so :

 

https://lkhill.com/using-influxdb-grafana-to-display-network-statistics/

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: