cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4913
Views
0
Helpful
5
Replies

portchannle in UCS any idea about the solution

mabuhantash
Level 1
Level 1

we create a Portchannel in the UCS but it show up in the switch and in the UCS show failed

since no operatioma member f0727 with this error ??

<faultInst

ack="no"

cause="membership-down"

changeSet=""

code="F0727"

created="2012-01-30T10:25:46"

descr="lan Member 1/19 of Port-Channel 10 on fabric interconnect B is down, membership: individual"

dn="fabric/lan/B/pc-10/ep-slot-1-port-19/fault-F0727"

highestSeverity="major"

id="41644"

lastTransition="2012-01-30T10:25:46"

lc=""

occur="1"

origSeverity="major"

prevSeverity="major"

rule="fabric-eth-lan-pc-ep-down"

severity="major"

status="created"

tags="network,server"

type="network">

</faultInst>

1 Accepted Solution

Accepted Solutions

No.  LACP is the only channeling option.

Regards,

Robert

View solution in original post

5 Replies 5

Robert Burns
Cisco Employee
Cisco Employee

Mohammed,

There appears to be an issue with the Port Channel negociation.  UCS FI intefaces can only negociate LACP Port channels, so ensure your upstream switch supports and is configured for LACP (802.3ad). 

Once you double check/fix this, disable the Port Channel and then re-enable it. 

If you're unsure, post the interface configuration of the upstream switch(es).

Regards,

Robert

mabuhantash
Level 1
Level 1

I think they use the nonegotiation mode in the upstream switch it not supported ??

No.  LACP is the only channeling option.

Regards,

Robert

becuase of that the portchannel in the upstream switch shows SU

I will try to give you the configuration withen 3 hours from now thanks

thaks

also I saw an issue in the chassis 1 as major post faluire error I think due to fan error is that possible

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: