Hey guys, hopefully this is an easy one. What is the maximum power draw that a 5108 chassis can handle? In other words, how many amps can the chassis actually take? I thought I heard 32A at some point, but I can't find it in any documentation.
The Cisco UCS 5108 Blade Server Chassis is powered by 208 V (220 V outside the US) 50-60 Hz AC. Up to four power supply units (PSUs) may be installed, each with a single C20 connector for input power connection to the UCS 5108 power supply.
Check the following document:
Hope this helps!
That's not what I was asking. This isn't in any of the cisco documentation I've seen. It's an oddball question, so don't worry about it.
Please review this table, I hope this will help.
200 to 240 VAC nominal (Range: 180 to 264 VAC)
50 to 60 Hz nominal (Range: 47 to 63 Hz)
15.5 Amps @ 200 VAC
Maximum Input VA
2790 VA @ 200 VAC
Maximum output power per power supply
2500 W @ 200 to 240 VAC (up to four power supplies)
Maximum inrush current
Maximum Heat Output
Maximum hold up time
Power supply output voltage
Climate Savers Gold
Efficiency (80Plus Gold Certified)
10% 20% 50% 100%
88.61% 91.64% 92.21% 90.97%
Please check the links mentioned below ,I hope this will help .