03-18-2014 11:21 AM
03-18-2014 03:47 PM
Raj,
I searched your CIBU part on Google and found this:
http://docwiki.cisco.com/wiki/Unified_Computing_System_C220_Hardware
Note: |
|
I also see CDW selling UCSC-C220-M3SBE= described as a M3S. The M3S is a 2.5" drive chassis.
Does that answer your question?
03-18-2014 12:31 PM
Hi Raj,
Not sure I understand the question completely but this SKU is for a C-Series 220 M3 platforms with support for Large Form Factor (LFF) Drives. The Spec Sheet for this system is available here: http://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-b-series-blade-servers/C220M3_LFF_Spe…
Jeff Foster
03-18-2014 03:42 PM
Hello Jeff,
Thanks for your reply.
But there are any CIBU servers based off of SAVBU Servers. I am trying to verify if | 11:37 AM |
CIBU's UCSC-C220-M3SBE is based off of SAVBU's UCSC-C220-M3L ? Regards, - raj - |
03-18-2014 03:47 PM
Raj,
I searched your CIBU part on Google and found this:
http://docwiki.cisco.com/wiki/Unified_Computing_System_C220_Hardware
Note: |
|
I also see CDW selling UCSC-C220-M3SBE= described as a M3S. The M3S is a 2.5" drive chassis.
Does that answer your question?
03-18-2014 04:36 PM
Hi Raj,
Robert's comments are correct and I saw these pop up just as I was starting my response. The M3S platform uses the 2.5" SFFdrives where as the M3L platform uses the 3.5" LFF drives.
Jeff
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: