09-17-2011 09:09 PM - edited 03-01-2019 10:04 AM
Hello
we have a Single chassis UCS 5108 and only one 6120XP with 2* 2104 FEX. Is there a possibility to connect 4 ports from both FEX into one FI ? What happens if I connect?
Solved! Go to Solution.
09-18-2011 03:23 AM
Hi Anand,
No you cannot connected both the IOM from the same chassis to the same FI. It is an un-supported configuration plus the second IOM will show up in the UCSM but will never come online with messages like un-supported configuration etc.
Plus it can also leave some faults in the UCSM which might need the chassis decomission and re-ack to be cleared.
Hope this helps!
./Abhinav
09-18-2011 03:23 AM
Hi Anand,
No you cannot connected both the IOM from the same chassis to the same FI. It is an un-supported configuration plus the second IOM will show up in the UCSM but will never come online with messages like un-supported configuration etc.
Plus it can also leave some faults in the UCSM which might need the chassis decomission and re-ack to be cleared.
Hope this helps!
./Abhinav
09-18-2011 07:45 AM
Hello
Thanks a lot. As this is my first time with UCS, was in a confusion comparing with other blade technologies.
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide