Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
602
Views
0
Helpful
1
Replies

SuSe Linux 11 on B200

Kassim Ismail
Level 1
Level 1

‎01-18-2012 02:34 AM - edited ‎03-01-2019 10:14 AM

Hi,

Has anyone installed SuSe Linux 11.00 on a B200 M2 blade? According to the UCS compatibility matrix, it is supported, but we are unable to get network connectivity. We have managed to carry out a SAN install & are able to boot of it, but cannot get network connectivity. We are using the Palo card & we can see eth0 & eth1 under YAST, cannot connect out.

I did download drivers for the Nic from the support site, but it only support SLES 11.00 SP1.

Any pointers/suggestions?

Thanks

Kassim

0 Helpful
1 Reply 1

Kassim Ismail
Level 1
Level 1

‎01-19-2012 01:25 AM

Hi All,

bit of an update. we have got nic connectivity now (misconfig on the UCS side). the question i now have is, does anyone know of any potential issues with using the built in drivers (enic & fnic) ? has anyone done such an install & where there any issues?

Thanks

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents

Review Cisco Networking products for a $25 gift card