cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
190
Views
0
Helpful
1
Replies
Zikki1981
Beginner

The system is not able to determine the FRU of the server in this slot. Replace the server and retry the operation.

Dear all,

 

We purchased old B200 M3 for our development environment and they are not discovered by our UCS Manager 4.X. We suspect that's because they came with a very old firmware (find some old bug around that with the same error message). Is there a way to upgrade them from UCS Manager as nothing is pretty much recognized? (slot issue and not detected server) If not, where do we find a 'manual' firmware upgrade to the last available firmware? (and a process if there is any)

 

Thanks in advance

1 REPLY 1
Kirk J
Cisco Employee

I've seen a number of cases that required replacement of the systemboard for this error.

You might want to try to temporarily remove/reseat the CMOS battery (leave it out for 10 min)

Doesn't sound like the server is getting far enough along in discovery to be able to adjust firmware....

 

cmos battery b200m3.JPG

 

Kirk...

Content for Community-Ad