12-05-2010 03:11 AM - edited 03-01-2019 09:45 AM
Hi
how can I set My UCS 6120 Xp to 1 Gpbs speed as Uplink to my Upsteream switch I have only 1 G CLC MM Gbig
MY UCS is 1.2 shall I need to Upgrade the software ????
could you help
Solved! Go to Solution.
12-05-2010 04:21 AM
Yes, you need to be on 1.3 to support the 1GB uplink option. With firmware 1.3 the first 8 fixed ports are the only ones that support 1GB.
12-05-2010 04:56 AM
12-05-2010 04:21 AM
Yes, you need to be on 1.3 to support the 1GB uplink option. With firmware 1.3 the first 8 fixed ports are the only ones that support 1GB.
12-05-2010 04:40 AM
I downloaded the software bundle 1.3(1) , I will do it tommorw at site , The Upgrade needs any technical Approval from cisco
or just follow the guide to make it
regards
12-05-2010 04:56 AM
12-05-2010 05:07 AM
Thanks for the reply
12-20-2010 07:26 PM
Using 1 gb uplink can lead to unpredicatable behavior. If load balancing on say esx is sending traffic between two hosts on the same fi it will be 10gb. If f it goes out say vnic1 on one host and back in vnic0 on the other it has to go via 1gb. Tis can lead to sometimes traffic between two servers is 10gb sometimes it's 1gb.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide