cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
601
Views
0
Helpful
1
Replies

UCS Admin account disabled

Paul James
Level 1
Level 1

Had a Monday morning moment

We have two UCS Servers UCS C220 M3L Firmware 1.5 (1f) recently built but not in production yet.

Noticed that the CIMC account was still admin and cisco so decided to create new administrator account.

First server no issues, but second created new user disabled admin but forgot to change user from read only before saving and logging off.

I have found admin password recovery procedure but will this work with a disabled account.

Advise welcome

1 Reply 1

padramas
Cisco Employee
Cisco Employee

Hello Paul,

If you connect a monitor and press F8 during boot sequence, you can enter CIMC config utility. From there you can reset the admin password and check it out.

If it does not work, you can enter the utility again and enable the option "CIMC factory default  "  and then re-configure networking options.

Padma

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: