Hello,
I installed our E140S yesterday in a remote office and used the HUU ISO to upgrade all of the hardware to the latest version. After doing this, every time I login I get a popup suggesting that I upgrade the Broadcom 5719 Firmware. I have located the 5719 zip file on the developer site (linked from the popup message) but it is unclear how I should go about installing it. Any input here?
Also, I have connected the Console and Dedicated ports, but have not configured the GE1 and GE2 ports yet. Any guidance on how I should do this? I was thinking I should use an unnumbered interface since all I want is to link it to ESXi 5.1, but wanted to get an idea of what best practice is. I assume the are "virtual" interfaces within the router and as soon as I configure them (either with or without an IP) the will come alive?
Thanks in advance.
Mark
