UCS Fabric Interconnect Capacity in Bootflash

[CiscoMedMed]

Both of my fabric interconnects are complaining about too little disk space. But I'm not sure where to go to see what junk I can delete from there. In UCS Manager there's no place in FI to show the contents of bootflash. I went to the CLI and tried connect nxos thinking maybe I could show bootflash: there. But no go. And the main CLI had no show boot. ??

Affected object:sys/switch-A/stor-part-bootflash

Description:Disk usage for partition bootflash on fabric interconnect A exceeded 70%

[Kirk J · Accepted solution]

It is usually firmware packages.

Go to equipment, equipment top object,,, then in right pane, firmware management,, then packages.

Delete any Infrastructure or B/C series bundles that you not using with your servers.

There can also be issues with left over tech supports, but usually it is lots of old previous firmware packages/bundles.

Kirk...