cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
253
Views
0
Helpful
1
Replies
Beginner

UCS MINI VHBA WWN cannot display from SAN switch

Hi,all:

 introduce hardware environment:

  UCS MINI 、 FI6324 、B200M3

 description the problem:

 when finish associate profile,  login to SAN switch, the VHBA adapter WWN  cannot appear .and login to FI6324,

 following output of  the command show interface brief ,

 -------------------------------------------------------------------------------
Interface  Vsan   Admin  Admin   Status      Bind                 Oper    Oper
                  Mode   Trunk               Info                 Mode    Speed
                         Mode                                            (Gbps)
-------------------------------------------------------------------------------
vfc3442    101    F     on     npmExtLinkD Veth11634                --
vfc3443    102    F     on     errDisabled Veth11635                --

-------------------------------------------------------------------------------

so what's wrong for the B200M3 ?

also refer attach picture errordisable.png

Everyone's tags (1)
1 REPLY 1
Highlighted
Cisco Employee

Re: UCS MINI VHBA WWN cannot display from SAN switch

Greetings.

Probably has more to do with the state of your upstream FC switch than your blade.

Please post the output from the following commands via NXOS on both FIs:

#show npv flogi-table

#show vsan 101

#show vsan 102

#show int fc x/y   (where x/y is your FC uplinks)

 

Thanks,

Kirk...

CreatePlease to create content
Content for Community-Ad
Software Conformance Survey