I followed the installation guide for installation of UCSPM 2.0 via the docker container (Control Center) web gui. Everything installed fine, but I get no access to the UCSPM URL via my web browser. Part of my question is, when asked for an IP address, was I wrong to use the same IP address I use to access the Control Center? The documentation is unclear but I thought that's what they wanted me to do.
The domain entry for my server is test-ucspm. So now my UCSPM CC is available via test-ucspm.domain.com, but I cannot access UCSPM itself at ucspm.test-ucspm.domain.com. So again - was I wrong to use the same address? If so, is there a way to change it? Or is there another reason I cannot access it?
Many thanks to anyone who can offer some sanity :)
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...