You can do this but the server needs to be in standalone mode first, then during post you can access WebBIOS (Ctrl+H depending on which controller you have) or if your server is running 1.5 CIMC firmware, then you can do that from CIMC without having to reboot to enter anywhere else.
Bottom line, that can be done but not through UCSM.
Our partnership with NetApp is stronger than ever with joint engineering development of the new FlexPod XCS. Introducing a new level of visibility and automation that can help propel your journey to hybrid cloud. The Cisco Intersight™ cloud operations p...
There is a prevalence of network threats across the world, and the rate, at which these threats continue to emerge, is more rapid than ever before. Cisco Next Generation Firepower (CNGFW) security technologies is information security service that provides...
Upload the Script to Datastore
1. Browse to any Datastore of ESXi Host2. Upload the folder "lsigetvmware_022817" ex. Suppose the datastore name is "Datastore3"
Run the Commands
Enable SSH of ESXi Host
SSH to ESX...
SymptomsCisco Prime is unresponsive. Web GUI will not load. Device doesn't respond to ping.DiagnosisPrime chassis is off.SolutionSince the CIMC uses Flash you can no longer use your bowser. SSH to CIMC address instead. show chassis detailChassis:Powe...
Very first data cloud — Evolution of data lake to hybrid cloud
Today, in this digitized world, data is being generated at a very high rate and from many different sources, and it is growing exponentially in many use ca...