06-04-2013 09:32 AM - edited 03-01-2019 11:03 AM
For so long I have been looking for some explanation or documentation about how works and measure the result in the performance tab in the FI on UCSM. This is very confusing because the value crosses the 100% all the time.
Anyone knows about it?
Thank you.
06-04-2013 09:35 AM
Hello Richard,
Can you please share UCSM version, FI model and a screen shot ?
Padma
06-05-2013 08:13 AM
Hello padramas,
The UCSM version is 2.0.2(q) and the FI is the 6140. Actually I have 5 chassis attached, I have noted this behaivor for so long.
In the screenshot look the %RX utilization column, sometimes the value cross the 100%.
Thank you.
Richard
06-05-2013 08:28 AM
Hello Richard,
On a closer look, % Util for Rx and Tx shows the same value as Rx and Tx Mbps counter.
We have enhanced GUI resolution counter via this defect
http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCuf76932
When the system has this fix, displayed stats for % util Rx / Tx should match expected behavior
% Utilization Rx = ( Rx Mbps value ) / Port speed capability
Padma
06-05-2013 07:37 PM
Padma,
Thanks a lot.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: