I have (3) B230M2 blades with M81KR CNA. In order to upgrade UCSM from 2.1.3 to 2.2.5 to add B200M4 blades into the environment, I am planning to replace the M81KR's with VIC1280's. I'm looking for any advice.
The blades are going to stay in the same slots they are in currently. I think I should be able to power them down, replace the hardware, re-ack the blade. It should be that simple right? Has anyone done this and have a "war-story" to share?
Our partnership with NetApp is stronger than ever with joint engineering development of the new FlexPod XCS. Introducing a new level of visibility and automation that can help propel your journey to hybrid cloud. The Cisco Intersight™ cloud operations p...
There is a prevalence of network threats across the world, and the rate, at which these threats continue to emerge, is more rapid than ever before. Cisco Next Generation Firepower (CNGFW) security technologies is information security service that provides...
Upload the Script to Datastore
1. Browse to any Datastore of ESXi Host2. Upload the folder "lsigetvmware_022817" ex. Suppose the datastore name is "Datastore3"
Run the Commands
Enable SSH of ESXi Host
SSH to ESX...
SymptomsCisco Prime is unresponsive. Web GUI will not load. Device doesn't respond to ping.DiagnosisPrime chassis is off.SolutionSince the CIMC uses Flash you can no longer use your bowser. SSH to CIMC address instead. show chassis detailChassis:Powe...
Very first data cloud — Evolution of data lake to hybrid cloud
Today, in this digitized world, data is being generated at a very high rate and from many different sources, and it is growing exponentially in many use ca...