I am having issues connecting a VIC1225 to our network, we were advised by our Cisco rep to purchase these as we required 10gb connection to our san/network. My network is a follows -
UCS C240 M4 SFF (Card 1) -> C3850 -> VNXe SAN
UCS C240 M4 SFF (Card 2) -> C3850 -> vCenter
we purchased 2 1225's and installed these in Slot 2 & 5. Now the 1225 cards show and i can configure them but i get no comms through the network. If we put a a i350 Quad 1gb card in the UCS i have no problem connecting to the network/SAN but if i replace this with the 1225 then it does not work.
The settings i have tried on the 1225 are -
Trunk/Access, VLAN/All/0, just having 1 card/2 cards.
Is there anyway to use these as just standard NIC's (as wont be using the virtual side) or am i missing some settings somewhere.
Any help configuring these would be a dream as i am lost now on how to get these working (most likely a simple configuration issue).
This article demonstrates the ability to toggle the boot order on a standalone C-Series server using the unified XML API. This is one of the many things that the programmatic nature of the API allows you to do, and helps facilitate and expedite initial sy...
Hello Team, I read a Cisco article back in Oct. 2019 on the UCS N20-C6508 blade chassis going EOSL on November 30th 2021 but now I am noticing on the Cisco Warranty online portal that its not showing any date announcements. I checked with Cisco ...
Since I was unable to find any info in the documentation or forums on this topic, I'm sharing my findings here. We did get boot to a M.2 SSD in RAID1 to boot ESXi on a new UCS Mini/FlashStack deployment with the new "UCS-M2-HWRAID Boot-Optimized M.2 RAID ...
We have discovered that sometimes UCS Server firmware doesn't always install properly. When you look at the server firmware, it displays sometimes like this;Firmware Version3.1(2f)C,3.2(3i)C Now we have track some of this down to human error. &...