When setting up a Hyper-V server using VM-FEX and SR-IOV is there a way to use VLAN's other than the Native VLAN on each dynamic NIC assigned to the virtual machines?
We have setup the port profiles and created the VM-FEX virtual switches inside Hyper-V and bound the Dynamic NIC inside the guest OS to the Port Profile. We have not been able to see a way to tag the traffic leaving the VM with a VLAN tag. You can't set the VLAN at the VM Settings page while the virtual switch is setup using VM-FEX like you normally would in Hyper-V (you get an usuported feature error). The Microsoft driver inside the VM and the VF driver also don't appear to support VLAN tagging.
We ahve been told by TAC that our setup is correct and that you can only use the Native VLAN. If this is the case then why do all the VM-FEX guides for Hyper-V include how to add Named VLAN's by CLI or GUI to the Port Profiles.
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...