vNIC in the wrong Port Channel

[CastleRobert]

This is my first time working in UCS so this might be something super simple I am overlooking.

I have two vNICs that are in the wrong PC and Im not sure how to change that. PC-32 & 33 is for data and PC- 42 & 43 are for iSCSI, the iSCSI boot to our equallogic keeps sitting in PC 33 instead of 43. This is only happening to 2 out 8 of my blades. Anyone able to point this newbie in the right direction to change this?  Thanks!

[CastleRobert]

Never mind, I figured it out finally.

[William_N_Dixon]

Can you post the resolution here

[Kirk J]

If you have vnics/veths showing pinned to an uplink that you don't expect, than you have an issue with either the assigned vlans at the vnic level, a static pinning policy,,, or you have an incorrectly configured disjoint layer2 config, and need to prune the un-intended vlans from the uplinks you don't want them on.

Kirk...