cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1210
Views
0
Helpful
2
Replies
Highlighted
Beginner

VNIC's don´t have link connection on operating system

Hello Everyone,


I'm configuring the UCS B-Chassis, and i'm having some problems with lan connectivity in all installed operating system.


All Interconnect LAN configuration seems fine, but the 2 NIC's on operating system don't have link connection.

In UCS Manager console i already check the DCE Interfaces and the Intel 10G NIC's configurations and they are in operable state.

Resuming, the UCS are all configured, but i don't have connectivity between Blades NIC's (eth0, eth1) and FEX's


Thank you in advanced

Regards,

Paulo Ferreira

Everyone's tags (2)
2 REPLIES 2
Highlighted
Beginner

Re: VNIC's don´t have link connection on operating system

try to set you 1st vnic to fabric A, and 2nd vnic to fabric B and enable auto fail over. After that, try to reset the connectivity on both fabric for the specified blade. You should have the uplink configured for Ethernet which I assumed.

Regards,

Craig

http://malaysiavm.com

Highlighted
Beginner

Re: VNIC's don´t have link connection on operating system

Paulo,

    

     If your 61x0 is configured in End Host mode and you do not have any uplink ports that are active then the link to the blade OS will be down.

Andre McGlown

CreatePlease to create content
Content for Community-Ad
Cisco Community May 2020 Spotlight Award Winners

Cisco COVID-19 Survey