when associating a service profile, does it verify total capacity availabilty
I tried to associate a service profile, it reports an error "insufficient-resources,vnic-capacity." Does it verify overcommitment of resouces againist physical capability when associating ? what checks are done during this task.
Re: when associating a service profile, does it verify total ca
The insufficient resources during association is specific to the blade or blade pool your trying to associate too. Before association can complete successfully many of the profile attributes are checked against the available resource your trying to associate too. This would include the number of network interfaces, number of hba interfaces as well as some of the policy definitions such as Disk policy.
Specific to your insufficient-resources,vnic-capacity error message, Menlo based adapters can only support 2 vNICS, also if you only happen to have one fabric interconnect you cannot have Hardware Failover enabled or it will generate that message.
Cisco UCS Platform Emulator, Release 4.0(4ePE1)
CONFIGURATION IMPORT NOTE: Importing configuration backups (All, System, or Logical) taken from the UCS Platform Emulator (UCSPE) to physical UCS Manager domains is not recommended or supported...
Many users of technology in today's workforce are considered "remote workers". We have laptops, tablets, smartphones, etc. that allows us to stay connected if we choose ~96.259% of the time (personal "guestimate" percentage). When you get down to ...
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•Field guides are meant to be used by customers for cleaning up an existing HyperFlex Edge or HyperFlex DC FI deployments for the purposes of reinstalling.
•The procedures in these guides are DESTRUCTIVE. Make sure all VMs and data...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...