cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

311
Views
0
Helpful
1
Replies
Highlighted
Advocate

Zoning, direct attached Netapp

UCS V2.2.1b, FC switch mode, Netapp filer direct attached with FC.

SP with 2 vhba, one mapped to fabric A resp.B., 2 FC target end point, one in fabric A, resp. B.

If I check the zoning done by UCS, I actually see 4 zones (SIST) ? why ? I would only expect 2 ??

xyz.png

xyz.png        

xyz.png

Everyone's tags (5)
1 REPLY 1
Cisco Employee

Re: Zoning, direct attached Netapp

The additional zones get created because of the wwpn targets added in the boot order policy. If you remove or add more targets it will add or remove additional zones

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here