paulc
Level 1
Level 1
Member since ‎08-18-2005
‎08-18-2017

User Statistics

  • 109 Posts
  • 0 Solutions
  • 45 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Does that above model and veresion of pix have a problem using AES for VPN's?  I've got three setups that are failing and the only commonality is that I have them configured to use AES.  The other tunnels I have are using 3DES and they're up and runn...
I am trying to set up a route and have the following routes (core 4510, edge 3750) (pertinent data in bold):On the 4510 a show ip route:     172.18.0.0/24 is subnetted, 2 subnetsC       172.18.2.0 is directly connected, Vlan182C       172.18.1.0 is d...
Hello, I am having trouble getting routing to work properly between two vlan's: Vlan2 and Vlan15 using a 2950 and 4510 core switch.On the 2950:    fa02 VLAN15    fa0/12  switchport mode TrunkFrom my computer, I can ping with success the pc on Vlan15....
I recently upgraded my Pix 515e from 6.3 to 7.08.  Upgraded pmd to adsm.  If I do a show ver, it states 7.08.  But, if I do show config, it still shows 6.3.Why would they be different?  Since adsm runs fine, I know that the upgrade went fine.
I wanted to increase memory from 64 to 128.  I removed 2x32 meg chips and added 1x128.  Show Mem command still shows 64 meg installed.  Do I need to have the second bank filled also before Pix will see the 128?
Community Statistics
Member Since ‎08-18-2005 06:41 AM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 109
Total Helpful Votes Received 5
Helpful Votes From