mfarrenkopf

mfarrenkopf · 02-13-2009

Is the port on the Procurve turned on? How about the encapsulation? It's dot1q?It really sounds like...

mfarrenkopf · 02-13-2009

Sounds like you've got a layer 1 issue. Even if the trunk is not working, you should still be gettin...

mfarrenkopf · 02-13-2009

I have a sup720 for which I have developed a configuration. I need to apply the config to the sup. C...

mfarrenkopf · 12-08-2008

We are using HSRP. However, I fall back to the fact that we were using HSRP prior to the reboot and ...

mfarrenkopf · 12-08-2008

I saw that, but nothing in there referenced the HMATM Learn proc. (It was included in sample outputs...

mfarrenkopf · 12-08-2008

I have a Cisco 3550-12G switch experiencing high CPU loads. For a long time (years?), CPU load has b...

mfarrenkopf · 08-29-2008

Giuseppe,Thank you very much for your quick reply!I did know that I can't use the EtherChannel as a ...

mfarrenkopf · 08-29-2008

I'm configuring a box to run ntop for some network data collection we need to do off of a 6500. One ...

mfarrenkopf · 02-05-2008

Perfect . . . that's what I thought. I tried searching for it, but was unable to locate. Thank you v...

mfarrenkopf · 02-05-2008

Understood. And from the description I posted as to how we have our ports connected, it *DOES* form ...

mfarrenkopf · 01-30-2008

We recently found a problem with a stacking cable. After resolving this issue, we decided it would b...

mfarrenkopf · 04-19-2007

I saw the previous post about using RDBMS sync and I'm looking into that.Best that I can tell, we do...

mfarrenkopf · 04-09-2007

We're using CS ACS 3.3. We've been asked to change all of the TACACS+ keys for all of our switches (...

Date Registered	‎12-27-2006 02:03 PM
Date Last Visited	‎05-14-2021 01:51 PM
Total Messages Posted	91
Total Helpful Votes Received	33

Re: Port down