lgontarsk
Level 1
Level 1
Member since ‎08-24-2006
‎08-18-2017

User Statistics

  • 115 Posts
  • 1 Solutions
  • 120 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Accepted Solution
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Hi,I have a frame-relay interface which has this config:interface Serial0/1/0:0.500 point-to-point ip address 157.130.35.6 255.255.255.252 ip access-group 100 in frame-relay interface-dlci 500 crypto map CRX0do you know what command will give you ...
Hi,I have an IPSEC VPn to a site at another company. I would like to add a static rout in our VPn router, pointing to one of the subnets on the interior of our IPSEc peer's network. But, I'm not sure what the next hop should be for the static route...
Hi,I have a VPN up & running, which connects to another company. I would like to put in a static route in my router with a destination of one of the subnets on their network.What should I use as the next hop for the static route... their end of the ...
Hi, I have an access-list with the following line... permit ip host 65.119.114.3 62.140.152.0 0.0.0.31and its crypto ipsec sa shows up as this, with no packets encaps or decaps. protected vrf: local ident (addr/mask/prot/port): (65.119.114.3/...
Hi, I have an IPSEC tunnel which has one end at my company and the other end at another company, whose routers I don't control. I have an ipsec tunnel which appears to come up (isa sa is qm_idle but the ipsec sa shows no packets encrypted or decrypte...
Community Statistics
Member Since ‎08-24-2006 03:41 PM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 115