Hi, I have just bought a Cisco C899G LTE, with the 4 pin square power plug. The router does not have a power brick with it - does anyone know what the pin-out is so I connect a temporary PSU? Cheers, Bill
Hi, I'm experimenting with the Cisco 819 series of routers. I have an operational 819-4G (without Wifi) and wondered if I could upgrade it by slotting in the Wifi module...I see from the motherboard there is a slot for an embedded AP 802 so I wondere...
Hi, I have a 1921 and 1941 and am using EHWIC-4G-LTE-GB for LTE/3G.I would like to get the GPS working but it only works very intermittently... controller Cellular 0/1lte sim data-profile 2 attach-profile 2lte gps mode standalonelte gps nmealte modem...
Hi, I am experimenting with 4G LTE cards - both EHWIC-4G-LTE-GB and C887VAG-4GThe result of sh cell x radio gives me the following information about both the cell site the radio is attached to, and tells me three cell sites are detected and usable:Id...
Hi, as title - can I successfully use two Cellular EHWIC cards in a 1921?I've tried using EHWIC-4G-LTE and EHWIC-3G-HSPA+7 but neither get IP address or cellular connection...I remember reading the bus or similar is limited in the 1921 (but not so m...
Thanks! I have also found a manual for the IR829 which gave me the same information, plus 'ignition noise suppression'!Cheers...Edit 1 - the router is running now, so the pin out is certainly correct!Edit 2 - pages 57 and 58 of the following document...
Hi and thanks... These commands force attachment to a particular carrier, as far as I can see - but I don't think they will force attachment to a particular cell site? Cheers!
Hi Paul,I was thinking of trying that next, but the script to set the network selection to auto - run two or three minutes after the router boots up - seems to work fine, and with (eg) a 3-UK sim, it connects to 3-UK fine with no intervention. It's j...