HiI am having an issue with SNMP post software upgrade on my 5508 WLC. I went from version 7.0.16.0 (I think!) to current version 8.0.100.0. My WCS is still running on verison 7.0.172.0. I tried the recommendations of restarting the WCS and also remo...
Hi AllI have been seeing some crazy stuff happening on a Cisco 887W Router since I brought it online. I am seeing the txload on the Dialer interface running at 255/255 the whole time, even with all LAN interfaces shut. Upon further investigation, I c...
Hi allWe are experiencing an issue with a B2B VPN. We are seeing traffic outbound but nothing in, and other end say the same. The VPN is established but no traffic is flowing. Below is tcpdum, was wondering if anyone can help with the little info pro...
Easy one for you chaps, I am sure!I am going to create a seperate management vlan across all my sites. I was just wondering if I am able to allocate a /32 to the SVI? I am pretty sure this will work, just wanting clarification as cant lab it right no...
GuysI am looking for some clarification on VLAN tagging that I hope you can hlep with, though reading back through previous posts it would appear perhaps a few of these area's may be part of Cisco's "secret workings"The way I understand VLAN tagging ...
Hi SandeepBig thanks for the reply. Can you tell me if the upgrade procedure is documented somewhere?Is it possible for me to backup the config from the current WCS and import it into PI? Or must that be a complete new install/config etc?Thanks again...
Hi GiuseppeThis is exactly my thoughts! I had to bring the figures into excel just read them!The router is working fine, but what concerned me was the txload on the dialer interface. With this number of pakcets, it will putting an unnecessary load o...
Hi ShrikantMany thanks for the prompt reply. This setting is for the other end of the VPN? Also I notice this is a global command, and we have lots of similar VPN's passing traffic no problemThanks
