We have a pair of ASR-1001HXs and each is receiving a full BGP table from their 4 neighbors (3 eBGP and 1 iBGP). This platform is capable of 3.5 million IPV4 routes with 16GB of memory (which we have). I am wondering if I'm hitting the 3.5 million ...
Hi -We have 3 switches - A, B and C. A is connected to B and B to C via lacp etherchannel dot1q trunks. There is no direct link from A to C.A is a VTP server. Additionally, it is our root bridge and has SVIs that act as default router interfaces f...
Hi,I'm having a problem converting this AP to LWAP. I've used the WCS and the standalone tool. Both report successful upgrades. However, upon reload, the AP enters a reboot loop. From there, I'm only able to reload an autonomous image and try ag...
Hi - I've just noticed a strange problem that's occurring on our network. However, I believe that it's a fairly new problem.Some of our switches are not allowing concurrent telnet connections to their vty lines. This is in spite of having multiple ...
I was setting up the APs for a new users lab when we discovered they had puchased LAPs instead of APs.I installed the current version of the IOS following the procedures outlined in "Converting a Lightweight Access Point Back to Autonomous Mode" on C...
@MHM Cisco World- I had a question out to TAC as well. They are telling me the limit DOES apply against all BGP learned prefixes not just what's installed in the IPV4 table. It seems to be another case of marketing literature not being clear.Thank ...
We are an end user of BGP. 2 of our eBGP sessions per router are with neighbors in the same AS. One neighbor is a 10Gb/s link that we prefer and the other is a 1Gb/s backup. Our 3rd eBGP session is to a commercial ISP that is another 1Gb/s backup....
Doesn't only the best path prefix get installed into the routing table? If I take a random prefix, there is only 1 route when I issue
show ip route x.x.x.x. If I issue show ip bgp x.x.x.x,
I have 7 paths but the best path is the same as what is in...
Hi Jonanthan, I thought that too. In my example, switch C was seeing the correct output from 'show vlan' but traffic wasn't being passed when I connected a host to an access port. Giuseppe's note warns not to equate vtp propagation w/ L2 connectivi...
