Hi guys,I need some advice on a NAT problem.I have R4 connected to R1 over a point to point serial link (Outside). IP addressing is 172.16.1.0/29 - .1 is on R1 and .2 is on R4. R4 has a loopback 3.3.3.3 (Inside). R1 is on a LAN with R2 and R3. The n...

Hi guys,When doing CCM labs, it is sometimes necessary to start with a fresh CCM config, i.e. no phones, no partitions, no CSS etc. Is there a quick way to clear the CCM config rather than to delete everything that's been configured individually?

Hi guys,I have a 2651XM router installed with an ATM-AIM module and a VWIC-1MFT-E1 card. This was decomissioned a while ago but it used to be in the production network and provided PSTN connectivity via an E1 circuit. The question is, that I expected...

Hi guys,I did a fresh install of CCM4.2(3) on an MCS 7835-H2 with 1GB RAM and dual 18.2GB hard drives. The problem is that the CCM service keeps stopping. I get the following message in event viewer:"The Cisco CallManager service terminated unexpecte...

Hi all,When I backup the Publisher to a share on the Subscriber (same LAN). It works. The tar file size is 365MB. When I specify a shared drive on a remote server, it fails. I've checked space/permissions etc. All ok.Any ideas? Log file is attached i...