About M. G.

M. G. · 01-08-2014

Hi, yup, that was my idea, in a simplified way . Hopefully it helps.Regards, Mate

M. G. · 01-08-2014

Hi, you can try something like this1-21-32-12-43-13-54-54-25-45-3Hope this helpsRegards,

M. G. · 01-08-2014

This document explains how the Unidirectional Link Detection (UDLD) protocol can help to prevent for...

M. G. · 01-08-2014

UDLD is used to prevent STP loops, therefore it L2 protocol and it does not run on the L3 interfaces...

M. G. · 01-07-2014

Hi, sorry, this eol document was for 2960G.This is the right one.http://www.cisco.com/en/US/prod/col...

M. G. · 01-05-2014

Hi, Under the table 2. Product Part Numbers Affected by This Announcementyou have C2960-48-TC-L list...

M. G. · 01-05-2014

Hi, here you go, you'd find the info you're looking for herehttp://www.cisco.com/en/US/prod/collater...

M. G. · 01-05-2014

Hi, try to add NAT to yout device. Something like this...int fa4ip nat outsideint vlan 1 ip nat insi...

M. G. · 01-05-2014

Hi, try this link, it might helphttp://www.cisco.com/en/US/docs/routers/access/1800/1861/software/fe...

M. G. · 01-05-2014

Hi, it depends on a service that you have with your ISP. If you've been assigned /29 public IP range...

M. G. · 01-05-2014

Hi, for example switch with 48 G ports + 2 SFP+ ports:48 Gbps in and out which is 96 Gbps.20 Gbps in...

M. G. · 01-05-2014

Hi, It is not 24x1G but 24x2G and 2x20G becuse you have input and output. And then you have 80 Gbps ...

Date Registered	‎01-11-2007 04:25 AM
Date Last Visited	‎10-14-2020 12:05 AM
Total Messages Posted	42
Total Helpful Votes Received	44

Five-Member 2960X Stack with 0.5-Meter Cables