About msrohman

msrohman · 03-04-2021

Hi all, Is it required for an Cisco outdoor 1562i or e model to have a NEMA enclosure installed as well? The data sheet mentions humidity are levels 0 - 95% , non-condensing. So I'm guessing that they're required?Cisco Aironet 1560 Series Outdoor Ac...

msrohman · 06-19-2020

Hi all, I'm attempting to build a mobility tunnel between an AireOS virtual wireless controller (8.8.130) and a C9800 virtual wireless controller ( 16.12.1s). Are these models and software images compatible for creating a mobility tunnel? The link...

msrohman · 03-15-2018

H all, Does anyone know why the placement of the Cisco ISE Web Auth portal is located within the internal network for this design guide below? Is that the preferred security design? Figure 21-4. https://www.cisco.com/c/en/us/td/docs/solutions/En...

msrohman · 02-23-2018

Hi all, I have a basic wireless lab configured (diagram attached), yet the Windows 7 wireless client doesn't not obtain an IP address. If I attach a wired Windows 7 PC to VLAN 95, it obtains an IP without a problem. I have the LWAP statically co...

msrohman · 07-27-2016

Hi All, I have a Cisco 3900E series router attached to a carrier MPLS provider. The MPLS Ethernet circuit is 100Mbps of CIR bandwidth. However, when the egress traffic of the MPLS interface reaches above 30Mbps, I receive alert notifications that th...

msrohman · 03-05-2021

Thanks for the response. We're looking at installing some of that model but they may get exposed to rain. I'm looking at the AP data sheet, but I couldn't find any information about being exposed to storms.

msrohman · 03-16-2018

Thanks Flavio. I guess I could see reasoning on putting the web auth portal on the DMZ. But it seems secure enough to place within the internal network,. -Mike

msrohman · 03-15-2018

Kurram, Sorry for the delay. Did you try connecting to the SSID via Cisco AnyConnect or Windows native wireless? I couldn't get it to connect via native, but I finally tried from Cisco Anyconnect client and it worked! I didn't think about using th...

msrohman · 02-23-2018

Thanks for the response, Flavio. I tried the steps above , but no luck. I was able to get the AP to use DHCP (VLAN 96) from the L3 switch (SW2) though I attached a debug from the WifI PC attempt to access the ssid GuestNet-Lab. -Mike

msrohman · 07-28-2016

We run LiveAction. It monitors QoS class, bandwidth, & interface loss. It also monitors bandwidth as well. We're polling for 5 minutes. SNMP provides the data. I had it polling for 1 minute last month. I would still see the alerts.

Member Since	‎05-27-2004 12:58 PM
Date Last Visited	‎02-16-2023 11:47 PM
Posts	121
Total Helpful Votes Received	10

User Statistics

User Activity

Cisco 1562 access point: NEMA enclosure required?

Mobility tunnel between C9800 WLC and AireOS WLC

ISE Web Auth portal network placement for Guest wireless access

Wireless client does not obtain DHCP IP address

QoS loss while bandwith utilization is low

Re: Cisco 1562 access point: NEMA enclosure required?

Re: ISE Web Auth portal network placement for Guest wireless access

Re: Wireless client does not obtain DHCP IP address

Re: Wireless client does not obtain DHCP IP address

We run LiveAction. It