About shoaib.usmani

shoaib.usmani · 07-29-2009

Hi,I am trying configure Cisco2821 for ISDN video using E1 PRI. I have looked into the documentations and configuration looks ok. The only thing I do not understand is how to configure 'voice class called number inbound/outbound' for secondary called...

shoaib.usmani · 07-12-2009

Hi,I will be doing an upgrade for Cisco Unity 5.x from Exchange 2003 to Exchange 2007. I will be following this guide http://www.cisco.com/en/US/docs/voice_ip_comm/unity/5x/upgrade/guide/ex/5xcuruge130.html#wp1359133. Could someone please tell me wha...

shoaib.usmani · 07-02-2009

Hello,I am using CUCM7.1 and have successfully set up Cisco Unified Mobility. My question is if a user makes a call using mobile phone (remote device), can that call be pickup by or swtiched to the desk phone without dropping the connection? Many tha...

shoaib.usmani · 02-12-2008

Hello folks,I have upgraded CUCM 4.1(3) to CUCM 6.0. But Cisco CallManager service is not running, though it is activated.I have not uploaded the phones and node licenses yet. Would Cisco CallManager service not run without license or it is a differe...

shoaib.usmani · 01-21-2008

hello,I am trying to upgrade CUCM from 4.1(3) to 6.0. When I install DMA 6.0(1)a to CUCM4.1(3), after installation I am not able to open CCMAdmin, DMAAdmin and any other pages. But when I uninstall the Informix Dynamic Server and DMA, the CCMAdmin an...

shoaib.usmani · 07-29-2009

Carlo,You are a star!!! This post has made my life much easier.. I have one final question and then I will let you go. You have 3 video endpoints 727085, 86 and 87 but in the voice class pool you have given the end numebr to be 727099, may I ask what...

shoaib.usmani · 07-29-2009

Hi Carlo,Thanks very much for this info. I have two questions here for you:1. What are your H.323 video endpoints in your network? i.e. Where is your dial-peer 9998 is sending IP calls to?2. Looking at your config, you have voice class called number ...

shoaib.usmani · 07-29-2009

Thanks, I'll try and see how it goes.

shoaib.usmani · 07-29-2009

Thanks Nick,Let me give it a go and see if that works.Regards,Shoaib.

shoaib.usmani · 07-29-2009

Hi Paolo,Thanks for your reply.What I am trying to do is to configure the 2821 voice gateway to make and receive ISDN video calls. I don't understand how to configure the voice class called number inbound/outbound numbers on the voice gateway. For ex...

Member Since	‎05-12-2005 06:41 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	40

User Statistics

User Activity

Video H320 Secondary Called Number

Cisco Unity UM Exchange 2003 to 2007 upgrade

Single Number Reach question

CUCM 6.0 Cisco CallManager service is Not Running

DMA Error during CUCM Upgrade from 4.1(3) to CUCM 6.0

Re: Video Call

Re: Video Call

Re: Video H320 Secondary Called Number

Re: Video Call

Re: Video H320 Secondary Called Number