Hi, I am confused about active/standby hardware failover cables. we put two cables, one is the serial cable and other is the state cable. what is the rule of these cables, and which one is responsible for exchange information about the other peer.reg...
Hi, If we try to download signature update, the cisco site will ask for cisco account with service agreement. how can i get this agreement? and can i get a service agreement for ips only, or its a global one?thanks
Hi, I want to know how to get a PAK number with a new ASA or IPS? also if I have an ASA, how can i get a PAK number for it? is it free or notwith regards
Hi, If i want to configure the IPS for auto update , it asked for update server ip address, what is this ip address? is this auto update configuration needed for signature update, or it is for other updates?regards
Hi,I found a route-map command in the ASA v8 command refernce, it has the same structure as the route-map in router. does this command function like the router one or it has different function.
Hi, I think the problem of internet browsing here is in the access list entry:access-list inside_access_in extended permit tcp any eq www any eq www because the source port will not be www(80), it will be a random number above 1024, and the destinati...
Hi, When the primary ASA goes down, and the secondary ASA became the primary one, it will take the primary ip addresses for inside and outside interfaces, so the new primary will have the same ip addresses for the old primary. so, no need to worry ...
Hi, I am not sure about your full configuration, but if you want to enable ISAKMP on a specific intrface use the command: Crypto isakmp enable interface_name The ISAKMP should start when you define this, if this is not the case, post your config, an...
Hi, I think in your situation you dont need to use active/active failover, why you dont use transparent active/standby stateful failover? you need active/active failover when you have multiple subnets, and you want to use failover for those subnets,...
