About Tommy Svensson

Tommy Svensson · 12-17-2014

Hi. Here is my config now and I can't seem to get it working. Any ideas why? Kind regards, Tommy

Tommy Svensson · 12-04-2014

Hi. I'm interested in how much traffic goes through my site-to-site tunnels. I have about 5 tunnels ...

Tommy Svensson · 11-26-2014

I have done the NAT-exemption on both ends to not make traffic destined for the tunnel not go out th...

Tommy Svensson · 11-26-2014

Hi.I'm having problems reaching internal services over my site-to-site tunnel while they have a NAT ...

Tommy Svensson · 11-24-2014

Found this thread and have kind of the same question, is it not possible in Cisco routers running IO...

Tommy Svensson · 11-24-2014

Hi. I'm wondering about NAT loopback. My problem is this: I have 1 router Cisco 2911 that is the def...

Tommy Svensson · 09-16-2013

Hmm, shouldn't you use a dyndns to be able to point at a hostname instead of that address? A hostnam...

Tommy Svensson · 09-16-2013

Not any static routes or anything, just using the routers as default gateway for the clients. I don'...

Tommy Svensson · 09-16-2013

This is what we did and it's working like a charm. See if you can get it working with this configura...

Tommy Svensson · 09-13-2013

Hi.We have a Main Site and two Branch Sites, Site B and Site C. We want to run IPSec Site-to-site VP...

Tommy Svensson · 10-04-2012

Hi.I have the following setup.As gateway to the Internet i have a Cisco 2911 router with IP 192.168....

Tommy Svensson · 01-30-2012

Hi.I have a Cisco 1921 router and it uses 99% of CPU and i cant seem to spot wich process that is ta...

Tommy Svensson · 01-27-2012

This switch was named:Cisco Catalyst 2960-8TC-SWhats a proper LAN Base switch of the 2960-series cal...

Tommy Svensson · 01-27-2012

How do i know if another switch is LAN Base? I had this recommended to me by a reseller for QoS mana...

Tommy Svensson · 01-27-2012

So im guessing i have the wrong switch then, or is it just the wrong software?

Hi. Here is my config now and