Thanks for your attention.Our devices are Cisco Catalyst 3110x for IBM Blade-HT.May you guide me for...

HiIn other forum, introduced me EEM for my purpose.My need is, after cisco is reloaded some command ...

HiApparently FastEthernet0 can not be chenaged.because this port is only management from AMM IBM.

HiIs there any solution that I set one cron or schedule in order to set some configuration after cis...

HiUnfortunately this problem is not solved.Is there any solution that I set one cron or schedule in ...

HiIf one port is flapping for every one minute (up down) ,what's happened for switches of STP domain...

Thanks for your reply.So,if one link is disconnected or connected,what is happened for switches of S...

HiAlmost in every I read document,mentioned that uplink fast sholud not be activated On transit node...

Hi againThanks a lot for your nice reply.I have some misunderstanding about STP and BPDU:1- Does any...

Hidominic.caron and soroushm thanks a lot for your attention.I have some mis-conception about BPDU.1...

HiAre BPDU sent on all port of switch with any status or sent only some status?On one switch with st...

Hi againI forgot another problem in configuration, if I set pagp related command "channel-group 1 mo...

Thanks for your attentionOutput of "show run" :-Interface port-Channel1Switchport access vlan 2Switc...

HiIn our project, we had to configure PAGP between catalyst cisco 3110.there is no problem in config...

HiIn new our project we had installed IBM blade center HT.now we have to add 2 catalyst 3110 switche...