Hello Masters,
Can we use uccx along with UCCE as IVR solution? If yes then what will be the call flow.
Please help me to understand the components required here.
Thanks.
Hi All,
I am trying to use two Cisco 8831 phones in linked mode (Daisy chain). One primary phone is configured in CUCM and showing registered.
Connected secondary base with primary phone via daisy chain cable.
When cable is plugged into the secondar...
Hi all,
is there any way to configure outbound dial-peer on the base of calling party number.
I have a requirement where i need to route all outgoing calls (from a particular phone number 2222) on specific PRI line (E0/0/0) and calls from other p...
Hi all,
i have a setup where CME is integrated with CUE.
calls are forwarded to unity when phone is busy or not answered after 10 rings.
From any external phone I am able to call unity voicemail pilot number and able to listen voicemail greeting.
I ...
Hi all,
Initially voicemail trigger was configured as 5 digit extension only..but calls forwarded unity were in e164 pattern and that was the problem. So after configuring new voicemail trigger in e164 pattern i was able to resolve this issue.
Than...
Hi Mohammed, I have update on this case.
When i directly call voicemail pilot number then I am able to reach voicemail pilot number and getting unity ivr message.
but still facing issue when call is transferred to voicemail pilot number. when noan ...
Hi Terry,
Thanks for your answeres, Now the last one....
Can we use the same steps to built new CUCM publisher from scrap ? Do we need to install whole cluster or just Publisher ?
