About ruben

ruben · 05-07-2009

Yes, Vista 64-bit

ruben · 05-02-2009

After upgrading to Cisco AnyConnect v2.3.0254 Outlook on the clients will not connect to the Exchang...

ruben · 03-28-2009

Hi... In SDM you can get some stats on top attackers and ports. However, when the log grows large it...

ruben · 03-05-2008

I stopped trying to find out of the problem some weeks ago and just used the SDM running from my own...

ruben · 02-21-2008

I have privilege 15.Removing "ip http path flash:" didn't help.Before upgrade we had IOS 14.3 and SD...

ruben · 02-21-2008

I have ereased our flash and installed new IOS and CME 4.2.The system works, but I get this error wh...

ruben · 02-21-2008

I have upgraded our 2811 router with the lastest IOS and CME. Everything works nice. I used the SDM ...

ruben · 02-14-2008

64MB flashWhat about .tar-files? Shall they always be extracted in the router or just copy the whole...

ruben · 02-14-2008

We have a 2811 router. Using nearly all functions (VPN, CME, Firewall etc).The flash is almost full,...

ruben · 11-08-2005

We have 32 static IP from our ISP.All of these are NAT 1-->1 from FastEthernet 0/1 to FastEthernet 0...

ruben · 08-12-2005

I found out this...:In ATA I set (instead of 91) the full number of the phone on UID0 = 73890891.I a...

ruben · 08-12-2005

Did you get this to work? If you did could you please post relevant CME and ATA config?

ruben · 08-12-2005

After going from SCCP firmware to H323 firmware the ATA does not registrer itselt to CME anymore... ...

ruben · 08-03-2005

We have a 2811 router.Does anyone have an example of firewall settings to allow inbound active FTP r...

ruben · 08-02-2005

Ok. I have searched some more and then my solution will be Cisco ATA 186 2-Port, a regular modem in ...

Re: Exchange over VPN connecting problems